TamaTown Tama-Go Screen Freezes and Glitches

[Shulk]

I decided to run one of my TamaTown Tama-Gos yesterday and shortly after I started it, it froze and black lines were all over the screen so naturally I pushed the reset button and downloaded my Tama again. But it happened again when I was removing one of my figures from the top. This hasn't happened to one of my other three before that I can remember, is there a way to prevent this from happening again? I know pushing the reset button isn't that hard but it is kind of annoying.

 

[~SkrillexGotchi~]

Is your Gotchi Figure causing it to freeze? If so, I recommend checking for anything gunky on the contacts where you connect the figure (and the bottom of the figure itself). If that isn't the case, then you may be pushing it in halfway to where it can't read the figure and confusing the unit. If that's still not it, it could be your batteries. What battery brand do you use?

If it's a trusted battery brand, then I have to ask you this one last question. Have you been taking it outside? Heat can make the Tamagotchi start freaking out in ways you don't expect it. So I would recommend putting your Tama-Go in a bag where the heat can't get to it.

 

[Shulk]

Is your Gotchi Figure causing it to freeze? If so, I recommend checking for anything gunky on the contacts where you connect the figure (and the bottom of the figure itself). If that isn't the case, then you may be pushing it in halfway to where it can't read the figure and confusing the unit. If that's still not it, it could be your batteries. What battery brand do you use?

If it's a trusted battery brand, then I have to ask you this one last question. Have you been taking it outside? Heat can make the Tamagotchi start freaking out in ways you don't expect it. So I would recommend putting your Tama-Go in a bag where the heat can't get to it.

It happened once when trying to remove the figure and another time I hadn't touched it until I looked at the screen. I was using Energizer I believe. It was rather hot in my room that day so maybe you're right about the heat. I hadn't run it in awhile so I forgot about any little problems. Thanks for you're input!

 

[~SkrillexGotchi~]

It happened once when trying to remove the figure and another time I hadn't touched it until I looked at the screen. I was using Energizer I believe. It was rather hot in my room that day so maybe you're right about the heat. I hadn't run it in awhile so I forgot about any little problems. Thanks for you're input!

No problem! Hope your Tama gets better! Sorry that it freezes.