measurements of a vintage tamagotchi

[Igel-Fullmetal]

I am getting an Angelgotchi for christmas. It is my first vintage and I wan't a way to protect it while I'm playing with it. I could get the case too, but it is as expensive as the toy itself, so I am planning on sewing a pouch for it. To do this however, I need the approximate length and width measurements of a vintage tamagotchi (it doesn't necessarily need to be the angelgotchi as almost all vintages are the same size.) once I am done, I will post the pattern and instructions for everyone to use.

 

[SailorRosette]

Well, I found if you "trace" a regular connection, I can make a vintage case... Its weird but it works. Although, I should mention I sew pretty close to the edges sometimes. If you go around the outside (Like an up and over) and then flip it inside out, Its a good size. Just make sure you make room for the tama to get inside. (Maybe a spot for the keyring/chain too.)

 

[Eternal Mametchi Fan]

They're almost exactly 2 inches long, about 1.5 inches wide, and 0.7 inches thick.

 

[Igel-Fullmetal]

They're almost exactly 2 inches long, about 1.5 inches wide, and 0.7 inches thick.

That is about 5.1 cm by 3.8 cm by 1.8 cm.